Warning Messages:

 

￿￿￿Displayed￿"￿￿￿￿￿Message

Description

Action

 

 

 

The printer has

Replace the printhead when

 

 

 

 

 

 

detected burned-

print quality becomes

 

 

 

out printhead

unacceptable or if the

 

 

 

 

 

 

elements.

printed bar codes are non-

 

￿"￿￿￿￿￿￿￿

 

compliant.

 

 

 

 

 

 

 

 

The printer missed

Readjust the media sensor

 

 

 

 

￿￿￿￿#￿￿

 

detecting a label

and recalibrate.

 

 

 

gap.

 

 

 

 

 

 

 

 

 

 

 

 

 

Power has been

The printer power switch

 

 

 

 

 

 

removed and

was turned ‘Off’, the line

 

 

 

shutdown is in

fuse has blown, or AC line

 

 

 

 

￿￿￿￿￿￿"￿￿￿￿￿￿￿￿￿￿￿

progress.

voltage has been lost.

 

 

 

 

 

 

 

 

The host has

To save changes, send a

 

 

 

 

 

 

pending

host reset command (in

 

 

 

configuration

DPL) or to discard changes

 

 

 

 

 

 

changes that will

perform a front panel reset;

 

￿￿￿￿￿￿￿"￿￿

not take effect until

see Section 4.0.6.

 

 

 

a ‘host reset

 

 

 

 

command’ is

 

 

 

 

issued.

 

 

 

 

 

 

 

 

 

The printer has

A possible low or

 

 

 

 

 

 

detected a low

fluctuating line voltage

 

 

 

operating voltage.

level. Try moving the

 

 

 

 

 

 

 

printer to another outlet. If

 

 

 

 

this condition persists call

 

##￿"￿￿￿"￿￿￿￿￿

 

for service.

 

 

 

 

 

 

 

 

Ribbon will soon

Replace ribbon when

 

 

 

 

￿￿￿

 

need replacement.

needed.

 

 

 

 

 

 

 

 

 

 

 

 

 

The printer was

If the condition persists,

 

 

 

 

 

 

unable to save

possible faulty Main PCB.

 

 

 

settings in

Call for service.

 

 

 

 

 

 

permanent

 

 

 

 

memory.

 

 

 

 

(Continued next page)

 

 

 

 

 

 

 

J693

 

73

Page 83
Image 83
Pitney Bowes J693 manual Description Action