Pitney Bowes J693 manual Media Sensor Adjustment, Media Type Sensor Type Sensor Eye Mark Position

￿

)The correct hardware adjustments, regular maintenance, and calibrations found in this section will help ensure continued peak printer performance.

5.0Media Sensor Adjustment

The laterally adjustable Media Sensor detects the presence of media and the top- of-form of all media types except continuous stock, which is set through programming. For proper detection, the Sensor Eye Mark should be positioned as noted in the table below. If messages such as ‘Out Of Stock’ or ‘Top of Form Fault’ appear, the sensor position may need adjustment.

	Media Type*	Sensor Type	Sensor Eye Mark Position
To	Standard die-cut	Gap	Near the middle of the label

*See Section 7 for an explanation of the media requirements. nadjust the Media Sensor position:

With the printer powered ‘On’, media loaded, and the access cover open, rotate the Printhead Latch forward to raise the printhead.

Pass the media through the Media Sensor then position the Sensor Eye Mark over the label’s TOF mark (see drawing next page) by grasping and

pmoving the Slide Tab ‘in’ or ‘out’.

Lower the printhead by rotating the Printhead Latch to the locked position. Close the Access Cover.

(Continued next page)

J693 39