4–67Commands
Lines, Horizontal
Purpose Defines horizontal lines.
Mode CREATE
Format HORZ
LT; R; SC; EC
STOP
HORZ The Horizontal Line command; enter HORZ.
LT Defines the line thickness, measured in 1/72” dots.
Enter a value of 1 or greater. Horizontal line thickness
expands downward from the given row.
RDefines the row to draw the horizontal line. Enter a
value ranging from row 1 through one less than the
length of the form. Character row or dot row is
specified based on the Scale command (page 4–88), or
use the CP.DP format (page 4–7).
SC Defines the starting column of the horizontal line.
Enter a value ranging from column 1 through one less
than the width of the form. Character column or dot
column is specified based on the Scale command (page
4–88), or use the CP.DP format (page 4–7).
EC Defines the ending column of the horizontal line. Enter
a value ranging from column 2 through the last column
of the form. The ending column must be greater than
the starting column. Character column or dot column is
specified based on the Scale command (page 4–88), or
use the CP.DP format (page 4–7).
STOP Stop indicates the end of the HORZ command; enter
STOP. If not entered, the IGP/PGL will expect another
set of Horizontal Line command parameters.