Execute Errors

70EXECUTE form count parameter FC error

This error occurs when the parameter specifying the number of blank forms to print was entered incorrectly. When this error occurs, the IGP/PGL will automatically revert to the Normal mode. Form count can be from 1 to 65,535.

71EXECUTE/DELETE form not found in the directory

An attempt was made to execute or delete a form which does not exist in the forms directory. When this error occurs, the IGP/PGL reverts to the Normal mode.

72EXECUTE EVFU load error

This error is generated only during the Execute Form mode while programming the EVFU. If more channels than lines per physical page are specified during a load sequence, this error is generated, and the IGP/PGL automatically reverts to the Normal mode.

73EXECUTE EVFU terminator invalid

This error is generated only during the Execute Form mode. The EVFU LOAD is missing an END LOAD code. If the line terminator cannot be deciphered, an error is generated, and the IGP/PGL reverts to the Normal mode.

74EXECUTE form too wide for current page setting

The form was defined in one orientation while sent to print in another orientation. Use the debug slash (/) when creating a form to show which element is out of bounds (see page C±2).

75EXECUTE form too long for current page setting

The form was defined in one orientation while sent to print in another orientation. Use the debug slash (/) when creating a form to show which element is out of bounds (see page C±2).

76EXECUTE page number error

An error was made while specifying the page number used with the form being executed. This error can be generated because of incorrect format or a page number that is too large. The specified page number can range from 0 to 99,999,999. Since the page number is part of the Execute command, the IGP/PGL will automatically revert to the Normal mode.

8±14

Error Codes

Page 346
Image 346
Printronix ThermaLine Series manual Execute Errors