Printronix ThermaLine Series manual Bar Codes ±81

Hn[.m]	Optional parameter to adjust the overall height
	(vertical expansion) of the bar code symbol (including
	the upper and lower 0.1±inch guard bands and any
	human readable data).
	Height adjustments are made in 0.1±inch increments;
	enter H and a value from 4 to 99 to select height
	adjustments from 0.4 to 9.9 inches. The default value is
	0.9±inch.
	.m is an additional number of dots for the bar code
	height. (Dots are in the current dot scale.)
BFn;L	Optional parameters for assigning a dynamic bar code
	data field location on a form and for designating the
	length of the data field. With these parameters, the
	actual data for the bar code data field is dynamically
	provided during the Execute Form Mode; the data is
	not specified during the Create Form Mode. To use this
	field, perform the following steps:
	a.	Enter BF.
	b.	Replace n with a number ranging from 1 to 255
		to identify the bar code field. The SR and SC
		parameters specify the exact location of the bar
		code field identified by n.
	c.	Replace L with a number equaling the total
		number of characters in the field. (The actual
		data provided dynamically during the Execute
		Form Mode can be less than L.)
	d.	The information for the data field is entered
		dynamically during the Execute Form Mode.
		(Refer to ªExecute Form: Dynamic Bar Code
		Dataº on page 4±55 in the ªCommandsº
		chapter.) Do not use the data field parameter to
		enter data when the BFn;L parameters are used.
		However, refer to the data field description for
		available characters.
DARK	Optional parameter to produce darker looking bar
	codes. Enter DARK. Refer to ªDark Printingº on page
	4±10 for more information.

Bar Codes 5±81