Printronix ThermaLine Series manual End, Terminates the Create Logo mode enter END

dot	Identifies a single dot position in the row. Enter each
	dot number used. Dots are numbered sequentially from
	left to right.
dot1±dot2	Identifies a series of dot positions within the row,
	including dot1 on the left end and dot2 on the right
	end. Enter the series of dot rows. Series of dot rows
	can be combined with single dot positions in the same
	command line.
END	Terminates the Create Logo mode; enter END.

Comments The logo is defined by specifying the overall size and the rows of data used. The actual number of logos you can create and store depends on the memory required for each logo.

The maximum logo size allowed is 252 rows high (3.5 inches) and 240 columns wide (4 inches). Values exceeding either of these dimensions will produce an error. To maximize memory space, do not define the vertical and horizontal length of the logo grid larger than is required to capture the design.

The printer produces a grid with 72 dots per inch vertically and 60 dots per inch horizontally. Consequently, a logo must be designed using this scale.

The Logo Call command (page 4±72) in the Create Form mode brings the predefined logo into a form. The starting row and column parameters refer to the upper left corner of the logo grid. Once created, the logo is ready to be used in any form and will print at the size shown.

Example The following program shown on the next page produced the tape holder logo.

Commands 4±75