Printronix ThermaLine Series 112 Introduction, Table 13. Execute Form Mode Commands

1–12 Introduction
Table 1–3. Execute Form Mode Commands
Command Mnemonic Description Page No.
Compressed Print DENSITY Defines the horizontal print density in characters per
inch (cpi). 4–33
Dynamic Alphanumeric
Data AFn Executes the dynamic alphanumeric data provided after the (cc) EXECUTE command. 4–54
Dynamic Bar Code Data BFn Executes the dynamic bar code data provided after the
(cc)EXECUTE command. 4–55
Expanded Print EXPAND Expands fonts vertically and horizontally. 4–60
Font FONT Selects a specific typeface, bold, slant (italic) factor,
and symbol set. 4–61
Ignore Sequence
On/Off IGON IGOFF Enables
the IGP/PGL to ignore all characters after the
Ignore Sequence On command is sent until the Ignore
Sequence Off command is sent.
See Note on Page 1–11.
4–65
Incremental Alphanumeric
Dynamic Data IAFn Executes the incremental dynamic alphanumeric data provided after the (cc) EXECUTE command. 4–57
Incremental Bar Code
Dynamic Data IBFn Executes the incremental dynamic bar code data provided after the (cc)EXECUTE command. 4–57
Line Spacing, Vertical LPI Defines the lines per inch (lpi) printing format. 4–66
Multinational
Character Set ISET Selects one of the 32 multinational character sets. Chapter 7
Normal Mode NORMAL Places the IGP/PGL in the Normal mode, where it does
not change the data stream but awaits the SFCC
followed by an IGP/PGL command.
4–77
Paper PAPER Selects features such as paper cutter, print intensity,
label
sensor , page orientation (portrait/landscape), and
print speed.
4–79
Reset RESET Deletes all forms and logos from the IGP/PGL
memory. 4–85
Select Format
On/Off SFON SFOFF Ignores all host–generated paper movement commands. See Note on Page 1–11. 4–90