Printronix ThermaLine Series manual ±1. Normal Mode Commands, Command Mnemonic Description

Table 1±1. Normal Mode Commands

Command	Mnemonic	Description	Page #
Compressed Print	DENSITY	Defines the horizontal print density in characters per inch (cpi).	4±33
Configuration	CONFIG	Reconfigures IGP/PGL parameters.	4±34
Create	CREATE	Places the IGP/PGL in the Create Form mode where all the Create Form mode
			4±39
		commands are available to design form elements.

Create Logo

Delete Form

Delete Logo

Directory

Execute

Expanded Print

Font

Ignore Sequence On/Off

LOGO

DELETE FORM DELETE LOGO DIRECTORY

EXECUTE

EXPAND

FONT

IGON

IGOFF

Places the IGP/PGL in the Create Logo mode, where logos can be defined using the appropriate dot placements.

Deletes a selected form name from the directory and IGP/PGL memory.

Deletes a selected logo name from the directory and IGP/PGL memory.

Provides a list of all defined forms and logos, logo assignments to forms, and memory usage and availability.

Executes a previously created form.

Expands fonts vertically and horizontally.

Selects a specific typeface, bold, slant (italic) factor, and symbol set.

Enables the IGP/PGL to ignore all characters after the Ignore Sequence On command is sent until the Ignore Sequence Off command is sent. See Note on Page 1±11.

4±74

4±41

4±42

4±43

4±49

4±60

4±61

4±65

Line Spacing, Vertical

Listen

Multinational Character Set

Normal Mode

Paper

Print File

Quiet

Reset

Select Format On/Off

Set Up

Printer Mode Scaling Mode

LPI

LISTEN

USET

ISET NORMAL

PAPER

PRINT

QUIET

RESET

SFON

SFOFF

SETUP

PMODE SMODE

Defines the lines per inch (lpi) printing format.

Removes IGP/PGL from the quiet state and enables IGP/PGL operation.

Use a multinational character set or create a custom user±defined character set.

Places the IGP/PGL in the Normal mode, where it does not change the data stream but awaits the SFCC followed by an IGP/PGL command.

Selects features such as paper cutter, print intensity, label sensor, page orientation (portrait/landscape), and print speed.

Prints a file from external memory

IGP/PGL operation is disabled until a Listen command is received. Any data sent to the LinePrinter Plus Emulation is unaffected by IGP/PGL commands.

Deletes all forms and logos from the IGP/PGL memory.

Ignores all host±generated paper movement commands. See Note on Page 1±11.

Automatically executes and loads the IGP/PGL commands into the printer at power±up or after a RESET command is sent.

Included only for compatibility; not recommended for use.

Included only for compatibility; not recommended for use.

4±66

4±71

Chapt. 6

4±77

4±79

4±83

4±84

4±85

4±90

3±2

N/A

N/A

1±8 Introduction