Printronix ThermaLine Series manual Lines, Vertical, Lt C Sr Er, Stop Vert

Lines, Vertical

Purpose	Defines vertical lines.
Mode	CREATE
Format	VERT
	LT; C; SR; ER
	STOP
	VERT	The Vertical Line command; enter VERT.
	LT	Defines the line thickness, measured in 1/60º dots.
		Enter a value of 1 or greater. Vertical line thickness
		expands to the right from the starting column.
	C	Defines the column where the vertical line begins.
		Enter a value ranging from column 1 through one less
		than the width of the form. Character column or dot
		column is specified based on the Scale command (page
		4±88), or use the CP.DP format (page 4±7).
	SR	Defines the starting row of the vertical line. Enter a
		value ranging from row 1 through one less than the
		length of the form. Character row or dot row is
		specified based on the Scale command (page 4±88), or
		use the CP.DP format (page 4±7).
	ER	Defines the ending row of the vertical line. Enter a
		value ranging from row 2 through the last column of
		the form. The ending row must be greater than the
		starting row. Character row or dot row is specified
		based on the Scale command (page 4±88), or use the
		CP.DP format (page 4±7).
	STOP	Stop indicates the end of the VERT command; enter
		STOP. If not entered, the IGP/PGL expects another set
		of Vertical Line command parameters.

Commands 4±69