Printronix ThermaLine Series manual Optional forms length parameter to specify, Disk

FL	The optional forms length parameter to specify the
	maximum length of the form. (Form length cannot
	exceed the physical length of the page. Refer to
	Appendix C). Specify the form length in one of three
	ways:
	a.	Enter 0 to define a form of unspecified length.
		The form will end after the longest element; that
		is, the form length is automatically controlled to
		contain all elements without extra length beyond
		the longest element. This can be used to
		eliminate wasted paper after producing short
		forms.
	b.	Enter a value for the form length ranging from 1
		to 65,535 to specify the forms length in dot
		rows. (12 dot rows per line = 6 lpi spacing; 9 dot
		rows per line = 8 lpi spacing.)

NOTE: Dot row range for setting the forms length depends on the forms

	length configuration. Refer to page 4±64 for information on how to
	configure the forms length.
	When the host form length configuration option is enabled, the form
	length and width values defined in this command, set the physical
	length and width page size.
	c. To specify the default forms length of 792 dot
	rows (11 inches at 6 lpi), do not enter a value in
	the form length parameter.
DISK	Optional parameter to store the form on the IGP/PGL
	external memory module. Enter DISK.

Example The following command creates a form named ORDER with the default forms length:

(cc)CREATE;ORDER

4±40 Commands