Printronix ThermaLine Series Configuration, Normal, Parametervalue, ±2. Config Command Parameters

Configuration

Purpose	Places the IGP/PGL in the Configuration mode, where changes to any or all
	of the IGP/PGL configuration parameters via software control can be made
	instead of from the printer control panel.
Mode	NORMAL
NOTE:	A separate line is required for the CONFIG command, the parameters and
	values, and the END command.
Format	(cc)CONFIG
	parameter;value
	END
	(cc)	The Special Function Control Character (SFCC).
	CONFIG	The Configuration command; enter CONFIG.
	parameter;value The parameter for which a configuration change is
		desired, and the value associated with that parameter.
		The available parameters are listed in Table 4±2, and
		the associated values are shown in Table 1±4 on page
		1±13.
	END	Terminates the CONFIG command; enter END.

Table 4±2. CONFIG Command Parameters

AUTO WRAP	LEFT MARGIN	SLEW RANGE
AUTO EJECT	RESET	TOP/BOTTOM MARGIN
CARRIAGE RETURN DEF	SFCC	UPPERCASE
LINE FEED DEF	SKIP PREFIX

4±34 Commands