Printronix ThermaLine Series manual Bold #, Slant #, Symset #, Point #

BOLD #	Selects a bold attribute. Enter BOLD, a space, and ON
	or 1 to turn bold on, or OFF or 0 for no bold attribute.
SLANT #	Selects a slanting factor. (Slant is similar to italic, but
	also offers a backward slant.) Enter SLANT, a space,
	and RIGHT or 1 for a typical italic slant, LEFT or ±1
	for a backward slant, or OFF or 0 for no slant attribute.
SYMSET #	Selects a font symbol set other than the default ASCII
	symbol set. Enter SYMSET, a space, and a value
	ranging from 0 to 31 representing the symbol set as
	identified in Table 7±1 on page 7±2 in the
	ªMultinational Character Setsº chapter.
POINT #	Selects the point size for the current typeface. Enter
	POINT, a space, and a point size ranging from 4 to
	999. Point sizes are available in quarter±point
	increments. Horizontal pitch is automatically adjusted
	based on the point size selected.
	The point parameter cannot be used when in CREATE
	mode. Use the point parameter of the alpha command.

NOTE: The fonts available are the standard font (#93779) and (#93952); OCR±A (#90993); and OCR±B (#91409). Other type face numbers will correspond to the CG Triumvirate font. CG Triumvirate is the proportional font and is available in the following point sizes.

5

6

8

10

12

14

18

24

30

36

Comments Font parameters in Normal and Execute modes do not affect the fonts that have already been established and saved on a form.

Font commands issued in the Create mode affect only the current form being created and not any of the fonts on other forms or for Execute or Normal mode text.

You can use any or all Font parameters, listed in any order, in a single Font command. (Do not list font parameters on separate lines.) Parameters and symbol sets not specified retain the previously selected value. Parameters incorrectly specified retain the previously selected value.

4±62 Commands