Printronix ThermaLine Series manual Execute Form Dynamic Bar Code Data, Format ccBFn Ddata fieldD

Execute Form: Dynamic Bar Code Data

Purpose Incorporates the dynamic bar code data into a previously identified location on a form.

Mode EXECUTE

Format (cc)BFn; (D)data field(D)

BFn	Indicates a dynamic bar code field (BF) and its data
	(n). Enter BF and replace n with the number of the
	data field corresponding to the number used to identify
	the field when it was defined with the bar code
	command during the Create Form mode.
D	The printable character (quotation marks for example)
	identifying the start and finish of the bar code data.
	Enter any printable character other than a slash (/), the
	SFCC, or a character used within the data. The same
	character must be used at both ends of the data field
	but will not be printed with the data.
data field	Enter the characters for the bar code data. The type of
	characters allowed in the data varies with the type of
	bar code. Refer to the data field descriptions for the
	selected bar code types.

NOTE: Commands can appear anywhere in the overlay text with PGL.

Comments The bar code location must have been previously identified using the BFn;L or BFn parameters of a bar code command in the Create Form mode. Then use the appropriate bar code command to enter the bar code data in that location. Inputting individual commands enters new bar code data into the identified location each time the form is printed.

You can repeat the (cc)BFn;(D)data field(D) sequence to complete as many bar code data fields as were defined on the form in the Create Form mode. You can also combine the Execute Dynamic Alphanumeric Data command in the same Execute command sequence. Each ªpageº of dynamic data (the dynamic fields, data, and overlay data) for the form must be separated from the next page of new dynamic data by a form feed.

Commands 4±55