
Or:
Enter a preprogrammed group of receiver numbers
(e.g., Group No. 1).
i)Press ●.
ii)Enter 1 at the keypad.
Note: | Entering O (zero) will cause you to transfer |
| to all terminals In all the groups (1 – 7). |
| Take care not to enter O unless so desired. |
iii)Press Yes (or press No to correct),
)) Either:
Enter another receiver number or group of num- bers; go back to step 8
Note Do not enter more than 30 receivers for one transfer operation
TRANSFER TRANS MODE
**KEYPAD
Groups Label
{
DISTRIBUTORS
**.YN
TRANSFERTRANS MODE
OUICK#D* KPAD START
Or: |
| |
If all required receivers have been designated, | NEW YORK OF F{LE | |
press Start | ||
DIALING | ||
| ||
Jotes: TRANSFER TRANS NIA |
| |
If this is displayed, the designated broad- |
| |
caster cannot transfer your message (its |
| |
memory may be full, or it may not have |
| |
the transfer function) |
| |
The broadcaster will be redialed after 5 |
| |
minutes. |
|
TRANSFER STANDBY
This means that a message was being received when you pressed Start. Then “TRANSFER STANDBY” is displayed. Transfer will start after the end of recep- tion.