Ricoh FAX75 manual Setting the Polling ID Code, Mode YIN

One of the following messages will be briefly displayed.

PROGRAMMED – the number has been stored into the group.

ALREADY IN GROUP – this number is already in this group.

CLEARED – this number has now been taken out of this group.

#NOT PROGRAMMED – no telephone number has been allocated to this key or code.

NOT IN GROUP – the number that you wanted to clear was not in the group. LONGHAND #’s FULL – you tried to program a full telephone number into the group but there are already ten telephone numbers used in groups.

Either delete an unwanted telephone number from all the groups, or program the new number as a Speed Dial code or Quick Dial key (mode 60) before storing it in a group.

8)The machine automatically returns to step 6.

GROUP	NO	1	KEYPAD	I
				~
	OUICKISPEEDf		KPAD	,

9-10 Setting the Polling ID Code

This four-digit code is necessary for polling and transfer request.

All concerned parties should decide on an ID code before transmission as, if their codes are not identical, the operation will fail.

Note:	Digits O to 9 and letters A to F can be used.
	Do not use 0000 or FFFF.
	I					I
1) Press the Function key and enter 62.		MODE		NO 62	YIN
						I
	I
	I	SET	ID	CODE?

2)Press Yes.

3)Enter a four-digit code at the keypad. e.g., 01 2A.

. Usekeys 0—9and A—F.

4)Press Yes to store the displayed code. Function 63 starts automatically.

I ID	CODE			—.
			KEYPAD/Y	I
0000				I
—
~			KEYPAD/Y
I
				I
ID	CODE		KEY PADIY
I	PROGRAMMED			I
MODE	NO	63	Y’
I SET	RTl~			I

9-14