Runco DTV-1200 owner manual Stationary Image Warning, Projector Warm UP

13FREEZ: press to freeze the projected image.

14TEXT: when adjusting one of the image controls, e.g. contrast, during a meeting, the displayed bar scale

can be removed by pressing 'TEXT' key first. To re-display the bar scale on the screen, press 'TEXT' key again.

15ENTER: to start up the adjustment mode or to confirm an adjustment or selection in the adjustment mode.

16Cursor Keys: to make menu selections when in the adjustment mode.or to increase or decrease the analog level of the image controls when they are first selected.

17EXIT: to leave the adjustment mode or to scroll upwards when in the adjustment mode.

18IR Output LED: lights up when a button on the remote control is pressed. (This is a visual indicator to check the operation of the remote control)

Start Up

Press the Power button on the remote; ensure the main Power button on the rear of the Projector is pressed in.

When this warm up cycle message appears on the screen, the menu offers the possiblity to start with a warm up period (press ENTER) or to skip this cycle (press EXIT). The number of minutes and the horizontal frequecy can be programmed in the 'Service mode' under the item 'Projector Set Up'.

Note: This warm up period is built in so that the Projector can quickly reach its operating temperature.

When starting this warm up period, a full white image is shifted on the CRT faceplate to avoid a burn in. Every 30 seconds a text box will be displayed on another place on the screen with the remaining time to go.

The image dimensions can be adjusted with the cursor keys to avoid scanning on the edges of the CRT's.

PROJECTOR WARM UP

A FULL WHITE PATTERN WILL BE

GENERATED FOR x MIN.

FOR IMMEDIATE USE OF THE

PROJCTOR, PRESS <EXIT>

WARNING : SKIPPING THIS

PROCEDURE CAN REDUCE THE

INITIAL PICTURE QUALITY OF THE

PROJECTED IMAGE;

YOU CAN ADJUST THE IMAGE

DIMENSTIONS WITH THE ARROW

KEYS TO AVOID SCANNING ON THE

EDGES OF THE CRT'S;

THIS OPTION CAN BE DISABLED IN

THE SERVICE MENU

with <ENTER>

<EXIT> to return

To interrupt the warm up period:

1Press EXIT, the warm up menu will be redisplayed with the remaining time indication.

2Press EXIT again to quit the warm up cycle and to display the source.

Start Up in a Specific Source

When the Projector is in Standby, it can be turned ON with a specific source. To do this, simply press the source number button (see page 19).

Stationary Image Warning

!	Do not display a stationary image with full brightness and contrast for longer than 10
	minutes, otherwise you risk damage to the CRT's.

16