Projector Address
Why a projector address?
Since more than one projector can be installed in a room, the separate projectors can be separately address- able with a Remote or a computer.
Set up an Individual Projector Address
The set up of a projector address can be done via the software.
See 'Change Projector Address' in Chapter 'Service Mode'
How to control the projector or projectors?
The projector's address may be set to any value between 0 and 255 which can be set in the Service Mode. When the address is set, the projector can be controlled now with:
-the Remote for addresses between 0 and 9.
-a Control System for addresses between 0 and 255.
Note: A projector will respond to a Remote set to the common address ('0' or '1') regardless of what address is set in the projector itself.
Common Address
Every projector has a common address '0' or '1'. The choice between '0' and '1' can be selected in the Service mode.
Before using the Remote
The Remote is default programmed with address 0 or 1, 'common address'. With that 'common address' pro- grammed into the Remote, every projector, with the same common address set up, will listen to the commands given by this Remote. If it is necessary to control a specific projector, than enter the projector address into the Remote (only when that address is between 0 and 9). The projector with the corresponding address will listen to that specific Remote.
Display the Projector Address on the Screen.
Press the ADDRESS key (recessed key on the Remote) with a pencil. The projector's address will be displayed in a 'Text box' (menu 1). This text box disappears after a few seconds.
PROJECTOR ADDRESS 001
To continue using the Remote with that specific address, it is necessary to enter the same address with the digit buttons (address between 0 and 9) within 5 seconds after pushing the address key. For example: if the Address key displays projector address 003, then press "3" digit button on the Remote to set the Remote's address to match the projector's address. Do not press 003 digits. This will address the remote control to '0' and control all projectors in the room.
If the address is not entered within 5 seconds, the Remote returns to its default address (zero address) and control all projectors in the room.
How to program an address into the Remote?
Press the ADDRESS key (recessed key on the Remote) with a pencil and enter the address with the digit but- tons within 5 seconds after pushing the address key. That address can be any digit between 0 and 9.
18
