Change Password
What can be done?
The password code (4 digits) can be changed to a new one.
This item is password protected. First the actual password should be entered before continuing.
Note:
Password function is only active if the jumper on the controller is in the 'ON' position.
How to select?
To select Change Password :
1.Push the cursor key 
or 
to highlight 'Change Password' (menu 1).
2.Press ENTER to display the password menu (menu 2).
If it is the first time you enter a password protected item, enter your password and press ENTER. The current password is displayed. The new password must consist of 4 digits between 0 and 9.
How to enter a new password?
Perform the following: |
|
|
1. Push the cursor key | or | to select the digits to be changed (menu 2). |
2.Press a numeric keys to enter the new digit.
3.Repeat for the other digits.
4.Press ENTER to save the new password.
Before saving the new password, a confirmation screen will be displayed (menu 3).
5.When the displayed password is correct, press ENTER to save.
6.If not correct, press EXIT to cancel the saving.
PROJECTOR SET-UP
IDENTIFICATION
RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
PROJECTOR WARM UP
POWER UP MODE: operating
COMMON ADDRESS: 0 Select with 
or then <ENTER>
<EXIT> to return
menu 1
PASSWORD
Enter new password :
| 0 0 0 0 |
| |||
Use |
| and |
|
| to select, |
|
| ||||
and reprogram
with numeric keys.
<ENTER> to confirm
<EXIT> to return
menu 2
CHANGE PASSWORD
!
Password will be
reprogrammed as xxxx
<ENTER> to confirm
<EXIT> to cancel
menu 3
56
