Runco DTV-1200 Change Projector Address, Change Baud Rate, Projector SET-UP Projector Address

Change Projector Address

What can be done?

Every projector requires an individual address between 0 and 255.

How to change the address?

To change the address, perform the following:

	PROJECTOR SET-UP	PROJECTOR ADDRESS
	IDENTIFICATION	Enter new projector address:
	RUN TIME
	CHANGE PASSWORD		0 0 0
	CHANGE PROJECTOR ADDRESS
	CHANGE BAUD RATE	Use		and	to select,
	PROJECTOR WARM UP		and reprogram
	POWER UP MODE: operating		with numeric keys.
	COMMON ADDRESS: 0	Highest address is 255
	Select with or		<ENTER> to confirm
	then <ENTER>
			<EXIT> to return
	<EXIT> to return
		menu 2
menu 1

1.Push the cursor key or to highlight 'Change Projector Address' (menu 1).

2.Press ENTER to select.

The Change Projector Address menu (menu 2) will be displayed and the actual address will be filled in. The first digit is highlighted.

3. Push the cursor key or to select the digit to be changed.

4.Reprogram with the digit keys on the Remote.

5.Press ENTER to confirm.

Change Baud Rate

What can be set up?

The communication speed between projector and computer has 8 possible speeds. The baud rate speed can be software set up.

The following baud rates are available: 38400, 19200, 9600, 4800, 2400, 1200.

How to set up?

To set up the baud rate:

1.Push the cursor key or to highlight 'Change Baud Rate' (menu 1).

2.Press ENTER to select. The actual baud rate will be highlighted (menu 2)

3.	Push the cursor key	or	to select the desired baud rate.
4.	Press ENTER to accept.

PROJECTOR SET-UP

IDENTIFICATION

RUN TIME

CHANGE PASSWORD

CHANGE PROJECTOR ADDRESS

CHANGE BAUD RATE

PROJECTOR WARM UP

POWER UP MODE: operating

COMMON ADDRESS: 0 Select with or then <ENTER>

<EXIT> to return

menu 1

BAUD RATE

Select new baud rate :

38400 19200

9600 4800

2400 1200

Select with arrow keys:

<ENTER> to accept

<EXIT> to return.

menu 2

57