Installation
10 Installation
The controller consists of the housing with the electronics and the back panel with the terminals. It is suitable for panel, wall, and top hat rail mounting (Fig. 9).
Panel mounting
1.Remove both screws (1).
2.Pull apart the controller housing and back panel.
3.Make a
4.Insert the controller housing through the panel
5.Insert one mounting clamp (2) each at the top and bottom or at the sides. Screw the threaded rod towards the panel with a screwdriver such that the housing is clamped against the control panel.
6.Install the electrical connections at the back of the housing as described in section 11.
7.Fit the controller housing.
8.Fasten both screws (1).
Wall mounting
1.Remove both screws (1).
2.Pull apart the controller housing and back panel.
3.If necessary, bore holes with the specified dimensions in the appropriate places. Fasten the back panel with four screws.
4.Install the electrical connections at the back of the housing as described in section 11.
5.Fit the controller housing.
6.Fasten both screws (1).
Top hat rail mounting
1.Fasten the
2.Slightly push the controller upwards and pull the upper hooks (5) over the top hat rail.
88EB 5179 EN