Samsung KFM2G16Q2A, KFN4G16Q2A warranty Continuous Linear Burst Read Operation

MuxOneNAND2G(KFM2G16Q2A-DEBx)	FLASH MEMORY
MuxOneNAND4G(KFN4G16Q2A-DEBx)

3.7.2.1 Continuous Linear Burst Read Operation

See Timing Diagram 6.2

First Clock Cycle

The initial word is output at tIAA after the rising edge of the first CLK cycle. The RDY output indicates the initial word is ready to the system by pulsing high. If the device is accessed synchronously while it is set to Asynchronous Read Mode, the first data can still be read out.

Subsequent Clock Cycles

Subsequent words are output (Burst Access Time from Valid Clock to Output) tBA after the rising edge of each successive clock cycle, which automatically increments the internal address counter.

Terminating Burst Read

The device will continue to output sequential burst data until the system asserts CE high, or RP low, wrapping around until it reaches the des- ignated address (see Section 2.7.3 for address map information). Alternately, a Cold/Warm/Hot Reset, or a WE low pulse will terminate the burst read operation.

Synchronous Read Boundary

Division	Add.map(word order)
BootRAM Main(0.5KW)	0000h~01FFh	Not Support
BufferRAM0 Main(1KW)	0200h~05FFh
		Not Support
BufferRAM1 Main(1KW)	0600h~09FFh
Reserved Main	0A00h~7FFFh
BootRAM Spare(16W)	8000H~800Fh	Not Support
		Not Support
BufferRAM0 Spare(32W)	8010h~802Fh
		Not Support
BufferRAM1 Spare(32W)	8030h~804Fh
Reserved Spare	8050h~8FFFh
Reserved Register	9000h~EFFFh
Register(4KW)	F000h~FFFFh

*Reserved area is not available on Synchronous read

3.7.2.24-, 8-, 16-, 32-Word Linear Burst Read Operation

See Timing Diagram 6.1

An alternate Burst Read Mode enables a fixed number of words to be read from consecutive address.

The device supports a burst read from consecutive addresses of 4-, 8-, 16-, and 32-words with a linear-wrap around. When the last word in the burst has been reached, assert CE and OE high to terminate the operation.

In this mode, the start address for the burst read can be any address of the address map with one exception. The device does not support a 32-word linear burst read on the spare area of the BufferRAM.

- 94 -