The Answering Machine
3 Enter the Remote Command corresponding to the operation within ten seconds.
•When the specified operation is complete, you hear a short beep. You can then enter another command for another operation. If you enter a remote code while the machine is responding to your command, the unit stops the current operation and performs new opera- tion. For the Remote Commands, "Using Remote Commands" below.
Using Remote Commands
4 Press #0 to finish the remote session. Important: if you don’t enter ‘#0’, your machine might not hang up for several minutes.
The chart below describes which Remote Code you have to enter for remote operation:
Code | Operation |
|
|
|
|
|
|
#0 | Exits remote control mode. |
|
|
|
|
|
|
#1 | Changes the greeting message. After entering the command, speak into the handset. When you finish, |
|
|
| press #. If you run out of recording time, the machine stops and plays back the message. |
|
|
|
|
|
|
#2 | Plays back all messages. The machine beeps and plays all messages. If there are no messages, the |
|
|
| machine beeps four times and waits for another command to be entered. |
|
|
|
|
|
|
#3 | Stops the ICM play and waits for remote code when playing ICMs (#2, #5). |
|
|
|
|
|
|
#4 | Skips a message backward. The machine skips the current message and plays the previous one. |
|
|
|
|
|
|
#5 | Plays back new messages. The machine beeps and plays all new messages. If there are no new |
|
|
| messages, the machine beeps four times and waits for another command to be entered. |
|
|
|
|
|
|
#6 | Skips a message forward. The machine skips the current message and plays the next one. |
|
|
|
|
|
|
#7 | Erases the message currently playing, and plays back the next message. |
|
|
|
|
| Chapter |
#8 | Turns TAM Mode on/off. The machine plays the greeting message when TAM Mode is turned on. |
| |
| Each time you press #8 thereafter, TAM mode is turned off, then back on. |
| |
|
|
| |
|
|
|
|
#9 | Erases all the messages. |
|
|
|
|
|
|
#✽1 | Activates Message Paging feature. If you do not set up Message Paging before you leave, you cannot |
|
|
| turn it on from a remote phone. You will hear error beeps. |
| 4 |
|
|
| |
#✽2 | Changes Message Paging destination number and activates the feature. Press #✽2. When you hear |
| |
|
| ||
| the confirm tone |
|
|
| a dial number. Use ✽ to insert a PAUSE between numbers. When you finish entering number, press |
|
|
|
| ||
| #. |
|
|
|
|
|
|
#✽3 | Deactivates Message Paging feature. |
|
|
|
|
|
|
✽#✽ | Exits the fax machine from answering mode. |
|
|
| This code is used at a phone extension connected to the same line as your fax machine |
|
|
|
|
|
|
