IBM 6.00E+04, 6C4 manual Exerciser Commands CMD, Abbreviations

option, additional menus, pop-ups and prompts may appear for each resource. Read any text and carefully fill out any prompts before committing. The System Exerciser Main Menu then displays. From this menu, the exercisers can be activated through option 1 where they will continuously run until halted (option 2) or exited (option x). See also the help text for information on how to use other available options.

When the task completes, any errors that were encountered are displayed for review. Finally, an Exerciser Complete popup displays. To continue, press Enter. You are then returned to the TASK SELECTION LIST menu. If miscompare errors were encountered, run diagnostics on the resource. If the problem is not reported, contact service support. If any other errors were encountered, select and run the Error Log Analysis task. If Error Log Analysis does not report a problem, contact service support.

Exerciser Commands (CMD)

Use the following commands as needed in the exerciser menus and reports. Not all commands are available in each menu or report.

CMD Description

aAcknowledge an error

bBack one page

cToggle between cycle count and last error

eView the AIX error log

fPage forward one page

qReturn to Main Menu

rRefresh screen

sEnable or disable beep on error

xExit system exerciser

Abbreviations

The following list describes abbreviations used in the exerciser reports.

Acronym	Description
COE	Continue on error (use number to select).
CP	Device has run the specified number of cycles and is not running.

DDThe exerciser has been terminated by a signal.

ER	Device has stopped with an error.
HG	The device is hung.
HOE	Halt on error (use number to select).
RN	Device is running.
ST	Device is stopped.

Chapter 6. Introducing Tasks and Service Aids 139