Step 12
1.If the terminal type has not been defined, use the Initialize Terminal option on the Function Selection menu to initialize the operating system environment before you can continue with the diagnostics. This is a separate and different operation from selecting the console display.
2.Select Diagnostics.
3.Press the Enter key.
4.In the following table, find the menu or system response you received when you selected Diagnostics. Follow the instructions given in the Action column.
System Response | Action |
|
|
The Diagnostic Mode Selection menu is | Select Problem Determination and go to ªStep |
displayed. | 13º on page 162. |
|
|
The Missing Resource menu is displayed. | Follow the displayed instructions until either the |
| Diagnostic Mode Selection menu or an SRN is |
| displayed. |
| If the Diagnostic Mode Selection menu is |
| displayed, select Problem Determination and go |
| to ªStep 13º on page 162. |
| If you get an SRN, record it, and go to ªStep |
| 15º on page 162. |
|
|
The New Resource menu is displayed. | Follow the displayed instructions. |
| Note: Devices attached to serial ports S1 or |
| S2 do not appear on the New Resource menu. |
| Also, ISA adapters do not appear unless they |
| have been identified and configured. |
| If the Diagnostic Mode Selection menu is |
| displayed, select Problem Determination and go |
| to ªStep 13º on page 162. |
| If you get an SRN, record it, and go to ªStep |
| 15º on page 162. |
| If you do not get an SRN, go to ªStep 18º on |
| page 163. |
|
|
The system does not respond to selecting | Go to ªStep 11º on page 160. |
Diagnostics . |
|
|
|
Chapter 8. Hardware Problem Determination 161
