IBM 6.00E+04 Sample File modemz0.cfg, # Componentname Espsetup Entry Service Processor Setup Z0

Sample File modem_z0.cfg

#

#COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP Z0

#FUNCTIONS: Modem configuration file for some early Hayes* compatible modems.

#This example uses the ATZ0 reset command to choose the factory defaults.

#This setup is recommended for modems that will respond to the ATZ0 command

#and which do not respond to the extended (&) commands. Refer to your modem

#manual.

#

#* Trademark of Hayes Microcomputer Products, Inc.

#(C) COPYRIGHT International Business Machines Corp. 1996

#All Rights Reserved

#Licensed Materials - Property of IBM

#

#US Government Users Restricted Rights - Use, duplication or

#disclosure restricted by GSA ADP Schedule Contract with IBM Corp.

#If the modem has configuration switches, they should be set to the

#factory default settings.

ICDelay 1
DefaultTO 10
CallDelay 120
#	AT	Attention Code	,	Inserts delay in dialing commands
#	Z0	Reset. Restore Profile 0 Q0		Turn on responses
#	E0	Turn echo off	Q1	Turn off responses
#	V0	Use numeric responses	S0=0	Automatic answer inhibit
# +++		Escape to command mode	S0=2	Answer on second ring
#	H0	Hang-up	X0=0	Limit modem	response codes
#			T =	Tone mode.	When used as T\r, it is a
#				no op to maintain program synchronization
#				when modem may/will echo the commands.
#
#	%N	Call-Out phone number	%P	Paging phone number

#%S Modem speed (available to users)

#Following are common responses from a wide range of modems:

#16, 15, 12, 10, 5 and 1 are connection responses. Add others as required.

#7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; 0=OK

#

# PROGRAMMING NOTE: No blanks between double quote marks (").

condout:	send "ATZ0Q0T\r"	# Reset modem.			Select profile 0
	ignore "0\r" or "OK\r\n" timeout 2	# Ignore modem			response.
	send "ATE0T\r"	# Initialize modem: Echo OFF,
	expect "0\r" or "OK\r\n" timeout 2	#	Enable	responses (Numeric),
	send "ATQ0V0X0T\r"	#	Limit response codes.
	expect "0\r" timeout 2	# Confirm		commands successful.
	send "ATS0=0\r"	# Set AutoAnswer OFF
	expect "0\r" timeout 2	# Confirm		command successful.
	done
connect:	send "ATDT%N\r"	# Tone dialing			command.
		# %N from		Call	Home setup.

# Expect a connection response.

expect "16\r" or "15\r" or "14\r" or "12\r" or "10\r" or "5\r" or "1\r" busy "7\r" timeout 60

done

retry: send "A/" # Repeat the previous command.

# Expect a connection response.

Appendix F. Modem Configurations 197