IBM 6.00E+04 Sample File modemf0.cfg, # Componentname Espsetup Entry Service Processor Setup F0

# responses.

expect "8\r" or "7\r" or "6\r" or "4\r" or "3\r" delay 2

done

Sample File modem_f0.cfg

#

#COMPONENT_NAME: (ESPSETUP) ENTRY SERVICE PROCESSOR SETUP F0

#FUNCTIONS: Modem configuration file for many recent Hayes* compatible modems.

#This example uses the AT&F0 reset command to choose the factory defaults.

#This set up is preferred for modems with extended (&) commands. For early

#vintage modems, setup Z or Z0 is recommended. If your modem responds to

#the extended (&) commands and to factory default choices (&Fn), but doesn’t

#work properly with this setup file, setup F1 is recommended.

#

#* Trademark of Hayes Microcomputer Products, Inc.

#(C) COPYRIGHT International Business Machines Corp. 1996

#All Rights Reserved

#Licensed Materials - Property of IBM

#

#US Government Users Restricted Rights - Use, duplication or

#disclosure restricted by GSA ADP Schedule Contract with IBM Corp.

#If the modem has configuration switches, they should be set to the

#factory default settings.

ICDelay 1
DefaultTO 10
CallDelay 120
#	AT	Attention Code	,	Inserts delay in dialing commands
# &F0		Reset. Restore profile 0 Q0		Turn on responses
#	E0	Turn echo off	Q1	Turn off responses
#	V0	Use numeric responses	S0=0	Automatic answer inhibit
# +++		Escape to command mode	S0=2	Answer on second ring
#	H0	Hang-up	X0=0	Limit modem	response codes
#			T =	Tone mode.	When used as T\r, it is a
#				no op to maintain program synchronization
#				when modem may/will echo the commands.
#
# &C1		Detect CD	&D2	Respond to DTR (often the default)
# &R1		Ignore RTS (CTS)
#
#	%N	Call-Out phone number	%P	Paging phone number

#%S Modem speed (available to users)

#Following are common responses from a wide range of modems:

#16, 15, 12, 10, 5 and 1 are connection responses. Add others as required.

#7=busy; 6=no dial tone; 4=error; 3=no carrier; 2=ring; 0=OK

#

# PROGRAMMING NOTE: No blanks between double quote marks (").

condout:	send "AT&F0Q0T\r"	# Reset modem. Select profile 0
	ignore "0\r" or "OK\r\n" timeout 2	# Ignore modem response.
	send "ATE0T\r"	# Initialize modem: Echo OFF,
	expect "0\r" or "OK\r\n" timeout 2	#	Enable	responses (Numeric),
	send "ATQ0V0X0T\r"	#	Limit response codes.
	expect "0\r" timeout 2	# Confirm		commands successful.
	send "ATS0=0\r"	# Set AutoAnswer OFF
	expect "0\r" timeout 2	# Confirm		command successful.
	send "AT&C1&D2&R1\r"	# Detect carrier and DTR,
		#	Ignore	RTS.
	expect "0\r" timeout 2	# Confirm		command successful.
	done

Appendix F. Modem Configurations 201