IBM 6C4, 6.00E+04 manual Call-In/Call-Out Setup Menu, CALL-IN/CALL-OUT Setup Menu

Call-In/Call-Out Setup Menu

Note: The information in this section regarding the configuring of serial ports, and modems attached to those serial ports, applies only to the serial ports (S1 and S2) on the CEC backplane (location U0.1-P1). These serial ports are normally used for call-in and call-out.

The call-out function is normally handled by the Service Focal Point running on the HMC.

None of these menus are applicable to the serial ports, or modems attached to those serial ports, on the HMC.

CALL-IN/CALL-OUT SETUP MENU

1.Modem Configuration Menu

2.Serial Port Selection Menu

3.Serial Port Speed Setup Menu

4.Telephone Number Setup Menu

5.Call-Out Policy Setup Menu

6.Customer Account Setup Menu

7.Call-Out Test

98.Return to Previous Menu

99.Exit from Menus

0>

vModem Configuration Menu, see ªModem Configuration Menuº on page 53.

vSerial Port Selection Menu, see ªSerial Port Selection Menuº on page 54.

vSerial Port Speed Setup Menu, see ªSerial Port Speed Setup Menuº on page 54.

vTelephone Number Setup Menu, see ªTelephone Number Setup Menuº on page 55.

vCall-Out Policy Setup Menu, see ªCall-Out Policy Setup Menuº on page 56.

vCustomer Account Setup Menu, see ªCustomer Account Setup Menuº on page 57.

vCall-Out Test tests the configuration after the modem is installed and configured correctly.

Note: If the system is running in Partition mode, this option is not supported.

52pSeries 630 Model 6C4 and Model 6E4 User's Guide