
Display Machine Check Error Log
Note: The Machine Check Error Log Service Aid is available only on Standalone Diagnostics.
When a machine check occurs, information is collected and logged in an NVRAM error log before the system unit shuts down. This information is logged in the AIX error log and cleared from NVRAM when the system is rebooted from the hard disk, LAN, or standalone media. When booting from Standalone Diagnostics, this service aid converts the logged information into a readable format that can be used to isolate the problem. When booting from the hard disk or LAN, the information can be viewed from the AIX error log using the Hardware Error Report Service Aid. In either case, the information is analyzed when the sysplanar0 diagnostics are running in Problem Determination Mode.
Display Microcode Level
This task is used to display the microcode or firmware levels of currently installed resources. When the sys0 resource is selected, the task displays the levels of both the system firmware and service processor firmware. sys0 may not be available in all cases.
You can display the current level of the microcode on an adapter, the system, or a
device by using the AIX diag command. See the following command syntax: diag
Flag Description
The AIX lsmcode command serves as a command line interface to the ″Display Microcode Level″ task. For information on the lsmcode command, refer to the AIX Commands Reference manual.
Display or Change Bootlist
This service aid allows the bootlist to be displayed, altered, or erased.
The system attempts to perform an IPL from the first device in the list. If the device is not a valid IPL device or if the IPL fails, the system proceeds in turn to the other devices in the list to attempt an IPL.