Column 2
(0)Logical processor device number assigned by AIX. You can display these logical device numbers by issuing the following command on the AIX
command line: lsdev
Column 3
(3.0) Processor address list used by the service processor.
Column 4
(00) Error status of the processors.
The error status of each processor is indicated by AB, where B indicates the number of errors and A indicates the type of error according to the following:
1.
2.
3.
4.Group integrity failure
5.
A status of 00 indicates that the CPU has not had any errors logged against it by the service processor.
To enable or disable CPU repeat gard, use menu option 77. CPU repeat gard is enabled by default.
If CPU repeat gard is disabled, processors that are in the ″deconfigured by system″ state will be reconfigured. These reconfigured processors are then tested during the boot process, and if they pass, they remain online. If they fail the boot testing, they are deconfigured even though CPU repeat gard is disabled.
The failure history of each CPU is retained. If a processor with a history of failures is brought back online by disabling repeat gard, it remains online if it passes testing during the boot process. However, if repeat gard is enabled, the processor is taken offline again because of its history of failures.
Note: The processor numbering scheme used by the service processor is different from the numbering scheme used by AIX. Consult the AIX documentation before configuring or deconfiguring a processor to ensure that the correct processor is selected.
Note: The number of processors available to AIX can be determined by issuing the following command on the AIX command line: bindprocessor
vMemory Configuration/Deconfiguration Menu
Enable/Disable Memory Repeat Gard
Memory repeat gard will automatically deconfigure a quad of memory during a system boot if a memory DIMM has failed BIST
Chapter 3. Using the Service Processor 47
