IBM 6.00E+04, 6C4 manual Modem Setup Z Setup Z0 Setup F Setup F0 Setup F1

If AT&F, configuration file modem_f.cfg is recommended.

If AT&Fn, configuration file modem_f0.cfg or modem_f1.cfg is recommended, depending on which provides the hardware flow control profile.

7.You have completed selection of the configuration file.

If your modem configuration selection is not available in the Service Processor Modem Configuration Menu, you must access it through the Configure Remote Maintenance Policy Service Aid.

If you find it necessary to adjust any of these configuration files, use the manual provided with your modem to accomplish that task. It is recommended you select settings that enable hardware flow control and respond to DTR.

Note: Some older modems do not respond to the X0 or &R1 commands. Edit out these commands from the modem configuration file if yours is such a modem. See your modem manual for more information.

Some modems, such as the IBM 7857-017, are not designed for the paging function. Although they can be used for paging, they return an error message when they do not get the expected response from another modem. Therefore, even though the paging was successful, the error message causes the service processor to retry, continuing to place pager calls for the number of retries specified in the Call-Out Policy Setup Menu. These retries result in redundant pages.

Examples for Using the Generic Sample Modem Configuration Files

The following table contains information to help you determine which modem configuration file to use with various modems.

Modem	Setup Z	Setup Z0	Setup F	Setup F0	Setup F1
		(Rare)
AT&T DataPort 2001				X
(Ring interrupt only on
first ring)
Bocamodem 1440E			X
Hayes Smart Modem	X
300
IBM 5841	X
IBM 5843	X
IBM 7851				X
IBM 7852-10				X
IBM 7855					X
USRobotics					X
36.6K Sportster
Zoom V.32			X

Appendix F. Modem Configurations 185