DOOR OPEN ALARM TIME SETUP

In this menu, you can set the delay time until the product triggers the door open alarm if the door stays open after the Door Relay time. To use this function, the Door Contact sensor should have been installed on the entrance door. (see page 17)

The default is ‘03’.

1.Press the F2 SETUP MENU button.

2. Use the buttons 4 and 6 to move to the OPEN ALR TIME item and press ENT .

3.Use the keypad to enter the time in two digits and press ENT .

00 : The alarm will sound shortly if the door stays open after the Door Relay Time.

01~ 98 : The alarm will sound shortly if the door stays open after both of Door Relay time and Door Delay alarm. (01~98 seconds)

99 : The Door Open alarm will not sound.

8.OPEN ALR TIME

03

8.OPEN ALR TIME

10

USER MANAGEMENT

MTo use this function, the Door Contact sensor should have been installed on the entrance door.

ARM/DISARM

With the ARM/DISARM code active, you can set the ARM mode by entering the ARM code and presenting the card (assigned Code 3 in registration) of a person who has the ARM/DISARM permissions. In this mode, all connected readers will not take the card input any further. To release the ARM mode, enter the DISARM code and present the ARM/DISARM card.

1.Press the F3 SETUP MENU button.

2. Use the buttons 4 and 6 to move to the ARM/DISARM SET item and press ENT .

3.You are prompted to enter the ARM code.

Use the keypad to enter the ARM code in two digits and press ENT .

4.You are prompted to enter the DISARM code.

Use the keypad to enter the DISARM code in two digits and press ENT .

MThe Arm/Disarm code should be different from the Duress Mode password.

You can specify the output time for each signal out when ARM function is enabled. (See Page 47 for “ARM/DISARM Output Setup”.)

2.ARM/DISARM SET

00/00

ARM CODE

00

DISARM CODE

00

English _ 41

Page 41
Image 41
Samsung SSA-S3010/EXP Door Open Alarm Time Setup, Open ALR Time User Management, Arm/Disarm Set, ARM Code Disarm Code