Schneider Electric 840 USE 106 0 manual Field, Functions, Hot Standby Quantum dialog screen

			ProWORX Nxt Configuration
Field and	The following table describes the functions of the fields of the <config extensions>
functions	<Hot Standby (Quantum)> dialog screen
Field		Function
Command Register		Use to specify the 4x register that will be used as the command register.
		Use this register to control various parameters of the Hot Standby system
Non-Transfer Area; Start Address		Use to specify first 4x register of a group of registers that will not be
		transferred from primary to standby PLC.
Non-Transfer Area; length		Use with the start address to specify the number of 4x registers that will
		not be transferred
State RAM Transferred		Use to select State Ram transfer options:
		All State Ram: all configured state ram transferred
		lRoutine only: all state ram defined in routine transfer table
		Default (12K):
			All 0x and 1X discretes up to 8192 each transferred
			All 3x and 4x registers configured transferred if combined they total
		l	less than 10000
			1000 3x and all 4x registers (up to combined total of 1000)
			transferred, if configured combined total of 3x and 4x registers is
		l	greater than 1000
		Routine and Extra: all state ram defined in routine transfer table and
		extra transfer table
Routine Transfer Table		Use to define the state ram (0x,1x,3x,4x) to be transferred every scan.
		Each input must be a multiple of 16 and 4x requires minimum of 16.
Extra Transfer Table		Use to define the state ram (0x,1x,3x,4x) to be transferred in multiple
		lscans. Each input must be a multiple of 16.
		Scans to Transfer: Used to specify the number of scans in which to
		transfer the extra state ram
Description
	The Command/Status Registers dialog is used to control or monitor various

parameters of a Quantum Hot Standby system.

840 USE 106 00 January 2003 219