Sharp AR-FX12 operation manual Using Edge Erase, Inkey.fax mode, touch the Special Modes

ERASING EDGE SHADOWS (EDGE ERASE)

The erase function is used to erase the shadow lines on copies produced when copying thick originals or books. The erase modes that can be selected are shown below. The erase width is approximately 10 mm (1/2") in it’s initial setting.

Your machine		The other machine
EDGE ERASE		Using edge erase
Erases shadows at edges
that appear when faxing
thick originals or books.
CENTRE ERASE	Transmission to
	other machine

Eliminates shadow lines produced by the bindings of bound documents.

EDGE + CENTRE ERASE

Eliminates shadow lines around the edges of copies and eliminates the shadow at the centre of copies.

Combining "edge erase" with "Dual page scan" on the following page

USING EDGE ERASE

1 Inkey.fax mode, touch the [SPECIAL MODES]

MODE SWITCH		If the address book screen
		appears,	touch	the
	ADDRESS REVIEW
		[CONDITION SETTINGS]
	SPECIAL MODES
		key to	display	the
SUB ADDRESS
		condition	settings screen
	FILE
		(page 1-5).
TO RECEPTION
	QUICK FILE
MEMORY:100%

4 If desired, set the width of the edge to be erased (touch the key or the key to set the width).

			The erase width can be
CENTRE
			set from 0 to 20mm in
		mm(0 20)
	10		1mm (0" to 1" in 1/8")
			increments.

2 Touch the [ERASE] key.

5 Touch the outer [OK] key.

AM ERASE

R 2in1 C

OK

CANCEL OK

You will return to the screen of step 1 and an edge erase icon will appear next to the [EXPOSURE] key.

To cancel the erase, touch the [CANCEL] key.

3 Select the desired erase mode.

				Select one of the three
ERASE
				erase	modes.	The
		CENTRE	EDGE+CENTRE
	EDGE
	ERASE	ERASE	ERASE	selected	key will	be

highlighted.

6 Send the fax as explained in "BASIC PROCEDURE FOR SENDING FAXES" (pages 2-2to 2-3).

NOTE

To cancel the erase function, touch the [CANCEL] key on the erase setting screen. (step 4)

3-4