Sharp AR-FX12 operation manual Programming AN F-CODE Memory BOX, Touch the BOX Name key

F-CODE MEMORY BOX / POLLING MEMORY No.001

BOX NAME

SUB ADRESS

POLLING TIMES

PROGRAMMING, EDITING, AND DELETING F-CODE MEMORY BOXES

The procedure for programming a memory box for F-code transmission is explained here. There are three types of F-code memory boxes: F-code polling memory (page 4-4), F-code confidential transmission (page 4-6), and F-code relay broadcast (page 4-8). Memory boxes are programmed, edited, and deleted as follows.

PROGRAMMING AN F-CODE MEMORY BOX

A box name, sub-address/passcode, and function must be programmed in a memory box.

NOTES

When programming a new memory box, a sub-address that is being used for another box cannot be used. The passcode, however, can be the same as a passcode used in another box.

A passcode can be omitted.

Up to 100 F-code memory boxes can be programmed. If 100 F-code memory boxes have already been programmed, a warning message will appear and you will not be able to program a new box. First delete an unused F-code memory box (page 6-13) and then program the new box.

1 Press the [CUSTOM SETTINGS] key and then touch the [ADDRESS CONTROL] key (refer to steps 1 and 2 on page 6-2).

2 Touch the [F-CODE MEMORY BOX] key.

O

F-CODE MEMORY BOX

3 Touch one of the memory box keys ([POLLING MEMORY], [CONFIDENTIAL], or [RELAY BROADCAST] ) on the store (upper) line.

CUSTOM SETTINGS
F-CODE MEMORY BOX					OK
				RELAY
	STORE	POLLING MEMORY	CONFIDENTIAL
				BROADCAST

5 Touch the [SUB ADDRESS] key.

				The	sub-address/
F-CODE MEMORY BOX / POLLING MEMORY
				passcode	entry screen
	No.001
				appears.
		BOX NAME	FAX INFORMATION

SUB ADDRESS

POLLING TIMES

6 Use the numeric keys (0 through 9) to enter a sub-address (max. 20 digits).

F-CODE MEMORY BOX / POLLING MEMORY		NEXT	EXIT
	No.001
SUB ADDRESS / PASS CODE		CANCEL	OK

ENTER THE SUB ADDRESS / PASS CODE VIA THE 10-KEY PAD,THEN PRESS [OK].

214341434

PASS CODE

The characters " " and "#" cannot be used in a sub-address.

AMEND/DELETE POLLING MEMORY CONFIDENTIAL

RELAY

If you enter an incorrect digit, press the [C] key and

BROADCAST

([POLLING MEMORY] is touched in the example here.) The F-code memory box programming screen appears.

4 Touch the [BOX NAME] key.

The "No." that automatically

appears is the lowest

number from 001 to 100 that has not yet been programmed. When the [BOX NAME] key is touched, the letter-entry

screen appears. Enter up to 18 characters for the name. For information on entering characters, see chapter 7 of the "Operation manual (for general information and copier operation)".

re-enter the correct digit.

If you do not wish to enter a passcode, proceed to step 9.

7 Tokey.set a passcode, touch the [PASS CODE]

				A slash (/) appears after
	CANCEL		OK	the sub-address.
-KEY PAD,THEN PRESS [OK].				If you enter an incorrect
				digit, press the [C] key
				and re-enter the correct
		PASS CODE		digit

6-10