Sharp AR-FX12 Anti junk fax setting, Fax polling security, Polling security setting

KEY OPERATOR PROGRAMS

Anti junk fax setting

This program is used to enter fax numbers from which you wish to block fax reception. Up to 50 (maximum of 30 on the AR-M351N/AR-M451N/ AR-M351U/AR-M451U) numbers can be entered. This program is normally disabled.

To block reception from the entered fax numbers, touch the [VALID] key.

Entering anti junk fax numbers

1 Touch the [ENTER] key.

The passcode entry screen appears.

KEY OPERATOR PROGRAMS

ANTI JUNK FAX SETTING

ENTER

DEKETE

2 Enterkeys. the fax number with the numeric

Up to 20 digits can be entered.

When you have finished entering the number, touch the [NEXT] key to store the number. A new number entry screen will appear. Enter the next number with the numeric keys.

3 Touch the [OK] key.

Deleting an anti junk fax number

1 Touch the [DELETE] key. The deletion screen will appear.

2 Touchdelete. the number key that you wish to

A message will appear. Touch the [YES] key to delete the number.

To cancel the deletion, touch the [NO] key.

Fax polling security

These settings are for using the Public Box for polling memory. Note that they do not apply to F-code polling memory. (see "USING THE POLLING FUNCTION" on page 3-14)

The "Fax polling security" are as follows: Polling security setting Passcode number setting

Polling security setting

When performing polling memory (See "polling security" on page 3-16),this setting is used to select whether any machine will be allowed to poll your machine, or only machines that have been programmed in your machine. Polling security setting is normally turned on (a checkmark appears in the box).

To allow any machine to poll your machine, touch the box to remove the checkmark.

NOTE

If polling security setting is enabled, enter the numbers of the fax machines to be allowed to poll your machine in "Passcode number setting" below.

Passcode number setting

When the polling security setting is turned on, use this setting to program (or delete) the fax numbers of the machines that are allowed to poll your machine. Programmed fax numbers are called passcodes. Up to 10 fax numbers can be programmed.

Programming passcode numbers

1 Touch the [ENTER] key.
The passcode entry screen appears.
KEY OPERATOR PROGRAMS
PASSCODE NUMBER SETTING	OK
ENTER	DELETE

2 Touch a blank key (a key in which no number appears).

KEY OPERATOR PROGRAMS

PASSCODE NUMBER SETTING

ENTER CANCEL OK

1/2

0743535521

0666211221

Keys with numbers cannot be touched.

If numbers have been stored in all of the keys, a message will appear and no further numbers can be stored. First delete a number that is no longer needed and then store the new number.

8-10