Sharp AR-FX12 Faxing a Large Number of Pages JOB Build Mode, Touch the JOB Build key

Press the [START] key. (See step 6.)

FAXING A LARGE NUMBER OF PAGES (JOB BUILD MODE)

The maximum number of pages that can be loaded in the automatic document feeder is 50. When you need to fax more pages than can be loaded in the automatic document feeder, use Job Build mode. This function allows you to scan the pages in sets.

If the memory becomes full while scanning the pages, a message will appear. To cancel the transmission, touch [CANCEL]. To transmit only the pages that have been scanned, touch [SEND].

Example: Scanning 100 A4 (8-1/2" x 11") size pages

Original

Page 1

50 pages

Page 51

50 pages

*Divide the original pages into sets of 50 pages or less, and scan the sets in order beginning from the set with the first page (first A then B in the above example).

1 In fax mode, touch the [SPECIAL MODES] key and then touch the key.

MODE SWITCH		If the address book screen
		appears,	touch	the
	ADDRESS REVIEW
		[CONDITION SETTINGS]
	SPECIAL MODES
		key to	display	the
SUB ADDRESS
		condition	settings screen
	FILE
		(page 1-5).
TO RECEPTION
	QUICK FILE
MEMORY:100%

2 Touch the [JOB BUILD] key.

SPECIAL MODES		The [JOB BUILD] key is
		highlighted.
JOB	FAX O	To cancel the selection,
BUILD	SE	touch the key once
		again so that it is not
MEMORY BOX		highlighted.

3 Touch the [OK] key.

5 Follow steps 4 through 7 of "BASIC PROCEDURE FOR SENDING FAXES". (See pages 2-2to 2-3.)

6 Press the [START] key.

The pages are scanned. When scanning is

finished,the

[READ-END] key appears in the touch panel.

7 Place the next set of pages in the automatic document feeder. (See page 1-7.)

8

9 Repeat steps 7 and 8 until all pages have

SPEAKER RESEND

OK

DUAL PAGE

SCAN

You will return to the screen of step 1.

been scanned, and then touch the [READ-END] key.

4 Place the original in the automatic document feeder. (See page 1-7.)

3-10