Sharp AR-FX12 operation manual Using a Program, Fax mode, load the document

PROGRAMMING FREQUENTLY USED OPERATIONS

This function allows you to store the steps of an operation, including the destination and scanning settings, into a program. This function is convenient when you frequently send documents, such as a daily report, to the same destination. Up to eight programs can be stored.

Programs can be stored using the custom settings, and a name up to 18 characters long can be assigned.

For information on storing, editing, and deleting programs, refer to "storing a program", and "Editing and

deleting programs" on page 6-8.
The following settings can be stored in a program:
Destination fax number		Polling	Erase
Dual Page Scan	2in1	Card shot	Resolution and exposure

Auto-dial keys (one-touch key, group key or speed dial key) are used to store the destination fax number. A full number cannot be entered. When storing a broadcast transmission or serial polling operation in a program, up to 500 (maximum of 300 on the AR-M351U/AR-M451U when a hard disk is not installed) destination fax numbers can be stored.

NOTES

A program differs from a timer transmission (page 3-6) in that it is not cleared from memory after transmission takes place. A program thus allows you to repeatedly perform the same type of transmission. Note, however, that programs do not allow you to establish a timer setting for transmission.

With the exception of polling, reception operations cannot be stored in a program.

3

USING A PROGRAM

1 In fax mode, load the document (page 1-7).

Do not load a document if you are performing a polling operation.

If you are going to use Dual Page Scan (page 3-5) and card shot (page 3-8), place the document on the document glass.

2 Touch the [SPECIAL MODES] key and then the [PROGRAM] key.

		If the address book screen
ADDRESS REVIEW		appears,	touch	the
SPECIAL MODES		[CONDITION SETTINGS]
		key to	display	the
	PROGRAM
FILE		condition	settings screen
QUICK FILE	TIMER	(page 1-5).

3 Touch the program key you wish to execute. Make sure the key is highlighted and then touch the [OK] key.

OK	The program key you
	touched is selected and
G.	you return to the screen
	of step 2.
RAM1	The [PROGRAM] key is
	highlighted.

4 Touch the [OK] key.

SPEAKER	RESEND	You will return to the
		initial screen.
	OK
DUAL PAGE
SCAN

5 If needed, set the original size and other settings, and then press the [START] key.

Transmission takes place according to the program.

NOTE

Select functions that cannot be stored in a program before you press the [START] key in step 5. These functions include specifying the original size (See "MANUALLY SETTING THE SCANNING SIZE" on page 1-8.), two-sided scanning (See "FAXING A TWO-SIDED ORIGINAL" on page 2-7.), and timer transmission. (See "TIMER TRANSMISSION" on page 3-6.)

3-17