1.5.22 Remote Mode Setup Parameter Commands

 

SC

Set Correction (Calibration) for Probe

See Section 7.6.1

WP

Set PID Constants

See Section 7.6.2

BF

Turn Blowers Off

See Section 7.6.3

BO

Turn Blowers On

See Section 7.6.3

SL

Set UUT Temperature Limits

See Section 7.6.4

SD

Set UUT Temperature Differential Limits

See Section 7.6.5

UP

Write SRAM Parameters to EEPROM

See Section 7.6.6

1.5.23 Remote Mode IEEE-488 (GPIB) Monitoring

The IEEE-488 bus controller is automatically reset if a problem is detected. No message to the user is generated as no data is typically lost in the process.

1.5.24 Setup Mode Easier Parameter Access

Setup parameters may now be accessed directly by number rather than having to scroll the entire list. If scrolling is used, there is now a backup key so the list can be scrolled in either direction. Likewise, for parameters that are chosen from a list, the list can be scrolled in either direction or the parameters can be keyed in directly without scrolling the list. See Section 8.1.

18

C4 Manual Rev 7.5.2

Page 18
Image 18
Sigma C4 manual Remote Mode Setup Parameter Commands