Instruction Manual

The following command will synchronize the live system with the new configuration.

# /bin/config –-run=ipconfig

Dial-in Configuration

To enable dial-in access on the DB9 serial port from the command line with the following attributes:

Local IP Address: 172.24.1.1

Remote IP Address: 172.24.1.2

Authentication Type: MSCHAPv2

Serial Port Baud Rate: 115200

Serial Port Flow Control: Hardware

Custom Modem Initialization: ATQ0V1H0

You would need to issue the following commands from the command line to set system configuration:

#/bin/config –-set=config.console.ppp.localip=172.24.1.1

#/bin/config –-set=config.console.ppp.remoteip=172.24.1.2

#/bin/config –-set=config.console.ppp.auth=MSCHAPv2

#/bin/config –-set=config.console.ppp.enabled=on

#/bin/config –-set=config.console.speed=115200

#/bin/config –-set=config.console.flow=Hardware

#/bin/config –-set=config.console.initstring=ATQ0V1H0

The following command will synchronize the live system with the new configuration.

# /bin/config –-run=dial-in

Please note that supported authentication types are ‘None’, ‘PAP’, ‘CHAP’ and ‘MSCHAPv2’.

Supported serial port baud-rates are ‘9600’, ‘19200’, ‘38400’, ‘57600’,

97

Page 104
Image 104
StarTech.com ECS0016 manual Dial-in Configuration, # /bin/config --run=dial-in