Instruction Manual
powerman - power on/off nodes
Synopsis
powerman [-option] [targets]
pm [-option] [targets]
Options
-1,--onPower ON targets. -0,--offPower OFF targets. -c,--cyclePower cycle targets.
-r,--resetAssert hardware reset for targets (if implemented by RPC). -f,--flashTurn beacon ON for targets (if implemented by RPC).
-u,--unflashTurn beacon OFF for targets (if implemented by RPC).
-l,--listList available targets. If possible, output will be compressed into a host range (see TARGET SPECIFICATION below).
-q,--queryQuery plug status of targets. If none specified, query all targets. Status is not cached; each time this option is used, powermand queries the appropriate RPC’s. Targets connected to RPC’s that could not be contacted (e.g. due to network failure) are reported as status “unknown”. If possible, output will be compressed into host ranges.
-n,--nodeQuery node power status of targets (if implemented by RPC). If no targets specified, query all targets. In this context, a node in the OFF state could be ON at the plug but operating in standby power mode.
-b,--beaconQuery beacon status (if implemented by RPC). If no targets are specified, query all targets.
-t,--tempQuery node temperature (if implemented by RPC). If no targets are specified, query all targets. Temperature information is not interpreted by powerman and is reported as received from the RPC on one line per target, prefixed by target name.
