StorageTek 312564001 manual OTD20055 Missing/invalid operand request rejected

OTD20055 Missing/invalid operand - request rejected

Explanation: A mandatory operand is missing from an DB2 Manager operator command.

Action: Re-enter the command with the correct syntax. Refer to “DB2 Manager operator interface” on page 50 for a description of operator command formats.

OTD20056 Errors altering configuration – check system status

Explanation: Errors have been detected attempting to alter the current DB2 Manager configuration using the operator SET command. Other messages will give details of the error encountered.

Action: Check the system status via the operator DISPLAY command to verify that the system configuration has not been altered erroneously.

OTD20057 Requested task tnnn does not exist - request ignored

Explanation: A sub-task specified in an operator command does not exist. The request is ignored. ‘t’ identifies the sub-task type (‘D’ – disk reader; ‘H’ – housekeeping; ‘S’ – scheduler; ‘T’ – tape reader; ‘W’ – writer) and ‘nnn’ gives the sub-task number.

Action: Ensure that the correct task number is specified in the operator command. If necessary, use the DISPLAY command to display details of all currently active sub-tasks.

OTD20058 Display processing completed

Explanation: Processing of an operator DISPLAY command has been successfully completed.

Action: None. This is an informational message.

OTD20059 Task tnnn is not active - request ignored

Explanation: A request to purge a sub-task in the control region cannot be performed because the task is either not initialized or already terminated. ‘t’ identifies the sub-task type (‘D’ – disk reader; ‘H’ – housekeeping; ‘S’ – scheduler; ‘T’ – tape reader; ‘W’ – writer) and ‘nnn’ gives the sub-task number.

Action: Ensure that the correct task number is specified in the operator command. If necessary, use the DISPLAY command to display details of all currently active sub-tasks.

DB2 Manager User Guide	149
StorageTek Proprietary