5.1.2. Setting the M102E Gas Measurement Mode

M102E OPERATING INSTRUCTIONS

M102E/M501 TRS

 

(Addendum to M101E Manual - P/N 04740 Rev A)

The output, labeled A3 is special. It can be set by the user (see Section 6.9.10 of the M101E Manual - P/N 04740 Rev A) to output many of the parameters accessible through the <TST TST> keys of the units Sample Display.

Output A4 is not available on the Model 102E Analyzer.

5.1.2. Setting the M102E Gas Measurement Mode

Setting the gas measurement mode on the M102E is identical to the method described in Sections

6.8.1of the M101E Manual - P/N 04740 Rev A except that the available measurement ranges are:

Table 5-1 M102E gas Measurement Modes

GAS

DESCRIPTION

MODE

 

 

 

 

The sample gas stream is stripped of any ambient SO2 by a special

TRS

chemical scrubber, then passed through a catalytic converter that

changes the TRS present into SO2 which is then measured using the

 

 

UV Fluorescence method

 

 

SO2

The sample gas stream bypasses the SO2 Scrubber and catalytic

converter allowing the only ambient SO2 to be measured.

 

TRS –SO2

The switching valve alternates the gas stream between the two paths

at regular intervals allowing the instrument to measure both gases.

 

 

 

5.2. SETUP – DIAG: Using the Diagnostics Functions

5.2.1. M102E Analog I/O Configuration

The following table supercedes Table 6-11 of the M101E Manual - P/N 04740 Rev A

Table 5-2: Analog Output Pin Assignments

PIN

ANALOG

VOLTAGE

CURRENT

 

OUTPUT

SIGNAL

SIGNAL

 

 

 

 

1

A1

V Out

I Out +

2

Ground

I Out -

 

 

 

 

 

3

A2

V Out

I Out +

4

Ground

I Out -

 

 

 

 

 

5

A3

V Out

not available

6

Ground

not available

 

 

 

 

 

7-8

A3

Not Used

Not Used

 

 

 

 

See Figure 3-4 for a the location of the analog output connector on the instruments rear panel.

26

05514 Rev A1

Page 32
Image 32
Teledyne SETUP - DIAG Using the Diagnostics Functions, Setting the M102E Gas Measurement Mode, M102E/M501 TRS, Rev A1