Teledyne 102E manual APPENDIX A-2 Setup Variables For Serial I/O, Revision A.2, Table A-2, Rev A.2

APPENDIX A-2: Setup Variables For Serial I/O, Revision A.2M102E/M501 TRS

(Addendum to M101E Manual - P/N 04740 Rev A)

APPENDIX A-2: Setup Variables For Serial I/O, Revision A.2

NOTE

Setup Variables for the M102E are the same as those for the M102E (see Appendix A-3

of the M101E Manual - P/N 04740110 Rev A) with the following exceptions:

Table A-1: Changed or added Setup Variables for M102E Software Revision A.2

SETUP VARIABLE	NUMERIC	DEFAULT	VALUE RANGE	DESCRIPTION
	UNITS	VALUE
MEASURE_MODE	—	SO2-TRS	SO2, SO2-TRS,	Gas measurement mode. Enclose
			TRS	value in double quotes (") when
				setting from the RS-232 interface.
TRS_SPAN1	Conc	400	0.1–50000	Target TRS concentration during
				span calibration of range 1.
TRS_SPAN2	Conc	400	0.1–50000	Target TRS concentration during
				span calibration of range 2.
TRS_SLOPE1	PPB/mV	1	0.25–4	TRS slope for range 1.
TRS_SLOPE2	PPB/mV	1	0.25–4	TRS slope for range 2.
TRS_OFFSET1	mV	0	-1500–1500	TRS offset for range 1.
TRS_OFFSET2	mV	0	-1500–1500	TRS offset for range 2.
CE_FACTOR1	—	1	0.8–1.2	Converter efficiency factor for TRS
				for range 1.
CE_FACTOR2	—	1	0.8–1.2	Converter efficiency factor for TRS
				for range 2.
REMOTE_CAL_MODE	—	SO2-	SO2-LOW,	Gas and range to calibrate during
		LOW	SO2-HIGH,	contact-closure and Hessen
				calibration. Enclose value in double
			TRS-LOW,
				quotes (“) when setting from the RS-
			TRS-HIGH	232 interface.
STABIL_GAS	—	SO2	SO2,	Gas to use to measure concentration
			TRS	stability. Enclose value in double
				quotes (") when setting from the RS-
				232 interface.

Table A-2:	Deleted Setup Variables for M102E Software Revision A.2
SETUP VARIABLE		NUMERIC		DEFAULT VALUE	VALUE	DESCRIPTION
		UNITS			RANGE
CONV_TYPE 2		—		MOLY	NONE,	Converter type.
					MOLY
CONV_SET 2		ºC	315		0–350	Converter temperature set point and
				Warnings:310–320		warning limits.
TEST_CHAN_ID		—		NONE	CONV	All other Test Channel settings are
					TEMP ,	the same as those listed in appendix
						A-1 of the M101E Manual - P/N
						04740110 Rev A

A-6 05515 Rev A.2