BioOptix™ 10
Section 2 Installation
2.1Unpacking the BioOptix 10 System
This section provides instructions for installing the system and preparing it for operation.
The BioOptix 10 system consists of a BioOptix 10 unit, a Foxy 200 Fraction Collector, and a Windows PC running BioOptix 10 software.
WARNING
The system is heavy. Use a two-person lift to prevent injury.
Carefully unpack the shipment and inspect the contents to verify receipt of all components against the packing list. If there is any damage to the shipping carton or any components, contact the shipping agent and Teledyne Isco (or its authorized represen- tative) immediately.
WARNING
If there is any evidence that the system has been damaged in shipping, do not plug it into the power line. Contact Teledyne Isco or its authorized representative for advice.
Compare the contents of the boxes with the enclosed packing slip. If there are any shortages, contact Teledyne Isco immediately.
2.2BioOptix 10 Installation
2.2.1BioOptix 10 Location The system should be installed on a work surface capable of sup-
and Space | porting the system, and buffer, sample, and waste containers. |
Requirements | The system is designed for ambient temperature and |
| operation. Refer to Table |
| The BioOptix 10 unit requires about 3350 square centimeters |
| (520 in2) of bench space. Space requirements are shown in Figure |
| |
| electrical connections. The left side of the unit should be kept |
| clear to access the power switch and for fluid connections. |
CAUTION
Ensure there is at least 10 cm (4 inches) of air space on its left side so that the disconnect device (power switch) may be eas- ily accessed in an emergency.
