Teledyne 10 manual AC power connection from pump module

BioOptix™ 10

Section 2 Installation

7.Plug the black power cord from the pump module into the receptacle at the lower part of the column module (Figure 2-8).

From

Pump

Module

Figure 2-8 AC power connection from pump module

8.Before completing the remaining cable connections, replace the back metal plate on the column module. The openings in the plate will fit around the connections made in steps 3 through 7. Secure the plate with the four screws (Figure 2-3). Then, reattach the tubing to the retaining clips.

9.The remaining ribbon cable connections are routed from the top of the pump module through the opening on the back plate of the column module. Refer to Figure 2-9 and complete the connections, matching the connector labels.

Not	P8	P11
Used

P6

P12

Tubing to pump

module

Figure 2-9 Ribbon cable connections

(top half of column module shown)

2-6