BioOptix™ 10

Section 3 Operation

Collect Effluent – Select the desired action for effluent fluid as it comes off the column. If Yes is selected, enter the desired fraction size.

 

 

Note

 

 

 

The Elute tab is a “Gradient” block type. See Appendix A.

 

3.5.5 Flush Settings

This block pumps fluid to flush remaining sample from the

 

column and system tubing. This step can prepare the column for

 

the next purification run, storage, or disposal.

 

The Flush tab is a fluid block type, therefore the settings dis-

 

played on this tab are the same as the Equilibrate and Wash

 

tabs. Refer to section 3.5.1 for a discussion on the settings for this

 

tab.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Figure 3-6 Flush tab settings

3.5.6Saving the Method File To be used in an experiment file, the method file must be saved. Save the method by selecting the File>Save menu command. Use a descriptive file name so that it can be located later.

3.6 Experiments

An experiment file can be created by:

selecting the File>New>Experiment menu command,

pressing the Ctrl+E keyboard buttons,

or by clicking the E toolbar button.

Before building and displaying the experiment file, you must select a method file that will be used for all ten channels. In the Select a Method for Experiment dialog box, locate and highlight the method file, then click the Open button.

An experiment file displays operating parameters in a table. Many of the columns in the table are determined by the template file used to create the method file. (Refer to Appendix A for more details on the template file.) Default values will be assigned to the table cells from the method file you’ve chosen.

3-7

Page 43
Image 43
Teledyne 10 manual Experiments, Flush Settings