Teledyne 10 manual Routing the Sample Out lines column module

BioOptix™ 10

Section 2 Installation

3.While facing the back of the column module, locate the two liquid tubing bundles secured to the lower-left inside case panel. Route these two bundles through the slots at the edge of the panel (Figure 2-4).

Route tubing through slots

To

Foxy 200

Figure 2-4 Routing the Sample Out lines (column module)

4.Connect the beige 25-pin connector from the pump module to the column module connector labeled Pump Controller. Refer to Figure 2-5.

From Pump

Module

Figure 2-5 Pump controller connection

2-4