Specifications

Model 7500ZA

 

 

 

When 4 components measurement is specified and “H” is specified at 22nd digit, 3 points is maximum for alarm output function.

note8) When “B” is specified at 24th digit, measuring range should be specified by ppm range code. In this case NO, SO2 and CO measuring range are corresponding range in mg/m3. Please refer to the table shown below for the corresponding range code based on “mg/m3”.

note9) When A to D is specified at 25th digit, the analyzer will be adjusted and delivered with the following gases.

Standard “A”: balance gas N2.

For heat treatment furnace “C”: balance gas 30vol% H2/remaining N2.

For converter “D”: balance gas CO, CO2.

When other adjustment is required, please specify “Z”.

When “Z” is specified, please attach a list of gas composition contained in the measuring gas.

Teledyne Analytical Instruments

108

Page 124
Image 124
Teledyne 7500ZA operating instructions 108