NDIR Gas Analyzer

Specifications

 

 

 

note1) When “D” is specified at 4th digit, Power supply cord is supplied in the scope of supply. Cord specification should be specified at the 20th digit.

note2) When only O2 measurement is necessary, “Y” should be specified at 6th digit.

note3) When “1” is specified at 7th digit, O2 pt analyzer signal has to be set as 0-1V DC linear corresponding to full scale.

External zirconia O2 analyzer and external O2 analyzer are not included in the scope of supply, and has to be separately ordered.

note4) Refer to Table 1 for possible combination of measuring components and ranges in this manual. When “Y” is specified at 6th digit, “Y” should be specified at 9th to 16th digit. For fuel cell O2 analyzer, range is 0-10vol% or more.

note5) Select the type of voltage rating, plug type and applicable standard of the power supply cord by 20th digit. Select a power supply cord for using at the location of end-user. When “A” is specified at 4th digit, Power supply cord will not be included in scope of delivery. When English is specified for display language, “E” should be selected at 20th digit.

note6) O2 correction is calculated only for NO, SO2 and CO.

note7) When 5 components measurement is specified, “H” must not be specified at 22nd digit.

Teledyne Analytical Instruments

107

Page 123
Image 123
Teledyne 7500ZA operating instructions 107