Timex W-184 manual Waypoints Mode example, Lap Data Mode functions, To Operate LAP Data

Waypoints Mode example

As a member of a local backpacking club, you volunteer to conduct trail clean-up before the opening of each camping season. Your map indicates various landmarks along the trail, but the trail itself has become overgrown. You move along the trail, clearing the underbrush to reveal the trail and at each landmark you set a waypoint on your Watch. When you reach the end of your designated clean-up route, you activate the Track Back feature to return to each landmark on your route and ensure you have properly cleared the trail.

Lap Data Mode

INDIGLO¨	▲
night-light	data value
To Summary	▼
Mode or hold
	data value
for time

Lap Data Mode functions

Lap Data Mode allows you to review stored lap information at any time. To record lap data, you must run the chronograph.

Once you restart the chronograph from zero for your next activity, lap data from the previous activity is erased.

NOTE: To view summary information for your entire activity, refer to ÒSummary ModeÓ on page 49.

TO OPERATE LAP DATA

1.Press MODE until the Lap Data Mode appears.

2.Press ▲ (DISPLAY) or ▼ (STOP/RESET) to navigate through lap data.

Each recalled lap will display three lines of data. The lower line will show the lap number labeled RCL (for recall) for each lap you stored in the chronograph.

TO VIEW PERFORMANCE DATA IN LAP DATA MODE

With the exception of lap and split times, Lap Data Mode relies on the Fitness Sensors.

If you only use one Sensor, information for the other Sensor will appear blank if you have set the Watch to hide blank data.

For information on data hiding, refer to ÒWatch settingsÓ on page 67.

46 47